Evaluate concrete quality in large deep foundation structures where large loads and lateral resistance are major factors with PDI’s vast array of QA products for drilled shafts and bored piles.

Pile Driving Analyzer® (PDA) System

The PDA evaluates shaft integrity, driving stresses and hammer energy when monitoring pile installation.
Learn More

CAPWAP® (Case Pile Wave Analysis Program)

CAPWAP is a software program that estimates total bearing capacity of a pile or shaft, as well as resistance distribution along the shaft at the toe.
Learn More

Thermal Integrity Profiler (TIP)

TIP evaluates the entire cross-section and length of a deep foundation using heat generated by curing cement to assess quality control and shape evaluation.
Learn More

Shaft Quantitative Inspection Device (SQUID)

A new technology providing measured load-penetration curves at the base of drilled shafts and bored piles.
Learn More

Cross-Hole Analyzer (CHAMP-XV)

The Cross-Hole Analyzer evaluates the quality of the concrete of deep foundations by the Crosshole Sonic Logging (CSL) method.
Learn More

PDI TOMO 3D Tomographic Software

PDI-TOMO is a 3D tomography imaging tool that supplements the CHAMP output. It combines arrival time data from the scans of all pairs of tubes. It then analyses these data and displays it in various views. This analysis is useful in cases where CHA-W analysis reveals a defect but does not give a precise idea of its extent.
Learn More

Pile Integrity Tester (PIT)

PIT conducts low strain integrity testing by pule echo or transient response methods.
Learn More